Fra: PSSO

PSSO DDA-2500

2.830,00  m/Moms
( 2.264,00  u/Moms )

PA Effektforstærker med switchmode PSU

2 x 1250W max med en vægt på kun 6,25 kg

Lager: På lager
Model/varenr.: 10451685
Stregkode: 4026397614466
  • Stereo PA amplifier with class D circuitry
  • Low weight and height due to integrated switch mode power supply
  • Reliable power amp with high impulse stability for a wide range of applications (e.g. compact PAs, multi-way PAs, concerts)
  • Limiter and speaker switch-on delay
  • 3 operating modes can be selected (stereo, parallel or bridged)
  • 2 calibrated level controls for precise level adjustment
  • Input sensitivity adjustable
  • LED VU meter and LEDs for activated protective circuit (protect), overload (clip), and signal per channel
  • Highly efficient front-to-rear air routing
  • Electronically balanced inputs via XLR mounting jacks, with XLR feed-through outputs
  • Speaker outputs via lockable Speaker plugs and screw terminals
  • Rugged steel chassis with aluminum front panel
  • Rack installation with 2 units
  • Housing design: (19") 48,3 cm rack installation
  • Height unit: 2 U
  • Power connection: Mains Input Socket (M) P-Con (Power-In) Power supply cord with safety plug (M) (provided)
Power supply: 100-240 V AC, 50/60 Hz
Power output (RMS):  
Stereo, parallel at 4 ohms 2 x 1250 W
Stereo, parallel at 8 ohms 2 x 700 W
8 ohms bridged 1 x 2500 W
Signal-to-Noise ratio: >100 dB
Total harmonic distortion: <0.15 %
Damping factor: >500
Voltage gain: 39.7 dB
Slew rate: >10 V/µsec
Input sensitivity: 0.775 V/1.0 V/1.81 V bzw. 39.3 dB/37 dB/32 dB, switchable
Input impedance: 20 kohms (balanced), 10 kohms (unbalanced)
Input connectors: 4 x XLR
Output connectors: 4 x Speaker, 4 x XLR feed-through output
Circuitry: Class D
Protection: Softstart, short-circuit, overheat, overload, clip limit, RF and VHF signals
Cooling: 2 temperature-controlled fans, front-to-rear
Controls: Power switch, input attenuators, mode switch stereo/parallel/bridged, input sensitivity
LED indicators: protect, clip, - 5 dB, - 10 dB, - 20 dB (per channel)
Construction: steel chassis, aluminum front
Dimensions: 483 x 307 x 89 mm
  Rack installation with 2 U
Weight: 6,25 kg
Power consumption: 200 W 1/8 power
Frequency range: 20 - 20000 Hz
Height: 8,9 cm
Depth: 30,7 cm
Width: 48,3 cm
Power/channel (4 Ohm): 1250 W
Power connection: Mains Input Socket (M) P-Con (Power-In) Power supply cord with safety plug (M)
Power supply: 110-240 V AC, 50/60 Hz