1. Forside
  2. Lyd
  3. Forstærkere 2-kanals
  4. Omnitronic XPA-1000
Fra: Omnitronic

Omnitronic XPA-1000

2.320,00  m/Moms
( 1.856,00  u/Moms )

Bugetvenlig PA effektforstærker på 2 x 500W max.

Mere information

Lager: På lager På lager
Model/varenr.: 10451033
EAN kode: 4026397593891
 
 
 
 
Features

PA amplifier with limiter, 2 x 500 W / 4 ohms, 2 x 375 W / 8 ohms

  • 2 operating modes can be selected (stereo or bridged)
  • Limiter, switchable
  • Speaker switch-on delay
  • 2 level controls
  • Each channel with LED for activated protective circuit (protect) and output meter with clip LED
  • Complete protection set
  • groundlift selector
  • Signal inputs via XLR or 6.3mm jack connectors
  • Speaker outputs via lockable speaker jacks and pairs of screw terminals
  • Additional Speaker plug for 8-ohm bridge operation
  • Class AB circuitry
  • Air flow from front to rear
  • The device is cooled by temperature-controlled fan
  • (19") 48.3 cm rack installation 2 U

Package contents

  • 1 x amplifier, 1 x user manual, 1 x power cord, 4 x foot, 4 x screw
Power supply: 115/230 V AC, 50/60 Hz
Power consumption: 710 W 1/8 power
Output power: 2 x 500 W RMS (4 ohms)
2 x 375 W RMS (8 ohms)
1000 W RMS bridged (8 ohms)
Power connection: Mains input via IEC connector (M) mounting version power supply cord with safety plug (provided)
Frequency range: 20 - 20000 Hz
S/N ratio: >95 dB
THD: <0,5 % at 1 kHz
Cooling: 2 x temperature-controlled fan , Air flow from front to rear
Impedance: Input: 20 kOhm , bal.
Input: 10 kOhm , unbal.
Circuitry: Class AB
Slew rate: >20 V/µs
Damping factor: >350
Control elements: Power switch, level control per channel, groundlift selector, limiter selector, mode switch (stereo/bridged)
Controls: Short-circuit; overheat; DC voltage; power on/off transients; softstart
Status LED: Power, level meter, clip, bridged, protect
Connections: Input: line via 2 x 3-pin XLR
Input: line via 2 x 6.3 mm jack socket (mono) mounting version
Output: speaker via 2 x speaker built-in socket (F)
Output: Speaker (bridge) via 1 x speaker built-in socket (F)
Output: speaker via screw terminal
Output: Speaker (bridge) via screw terminal
Input sensitivity: 1,4 V
Max. level: Input: +21 dBV
Input: +9 V
Housing design: (19") 48.3 cm rack installation 2 U
Dimensions: Width: 48,3 cm
Depth: 35,4 cm
Height: 8,9 cm
Weight: 9,05 kg