PSSO HSP-1000 demo

2.500,00  m/Moms
( 2.000,00  u/Moms )
PA Effektforstærker 1000W max.
Lager: På lager
Model/varenr.: 10451682demo

PA Effektforstærker på 1000W max med switchmode strømforsyning

Demomodel med original emballage. Som ny.

  • Stereo PA amplifier with class AB circuitry
  • Low weight and height due to integrated switch mode power supply
  • Reliable power amp with high impulse stability for a wide range of applications (e.g. compact PAs, multi-way PAs, international concerts)
  • Limiter and speaker switch-on delay
  • 3 operating modes can be selected (stereo, parallel or bridged)
  • 2 calibrated level controls for precise level adjustment
  • Input sensitivity and limiter adjustable
  • LED VU meter and LEDs for activated protective circuit (protect), overload (clip), and signal per channel
  • LEDs for parallel and bridge mode
  • Complete protection set against short-circuit, overheat, clipping, overload, DC voltage and VHF signals
  • Highly efficient front-to-rear air routing
  • Electronically balanced inputs via XLR mounting jacks, with XLR feed-through outputs
  • Speaker outputs via lockable Speaker plugs and screw terminals
  • Rugged steel chassis with aluminum front panel
  • Rack installation with 2 units


Power supply: 230 V AC, 50 Hz ~
Power consumption: 1000 W (1/8 power)
Power output (RMS):  
Stereo 4 ohm 2 x 500 W
Stereo 8 ohm 2 x 310 W
8 ohm bridged 1 x 1000 W
Frequency response: 20-20000 Hz
Signal-to-Noise ratio: >80 dB
Total harmonic distortion: <0.1 %
Damping factor: >200
Voltage gain: 38 dB
Slew rate: >20 V/µsec
Crosstalk: >70 dB
Input sensitivity: 32 dB/1.0 V/0.775 V, switchable
Input impedance: 20 kohms (balanced), 10 kohms (unbalanced)
Input connectors: 2 x XLR
Output connectors: 2 x Speaker, screw terminals, 2 x XLR feed-through output
Protection: Overheat, overload, short-circuit, over-current, DC voltage, softstart, VHF signals
Cooling: 2 temperature-controlled fans, front-to-rear
Controls: Power switch, input attenuators, mode switch stereo/parallel/bridged, input sensitivity
LED indicators: parallel, bridge (globally), protect, clip, signal (per channel)
Construction: Steel chassis, aluminum front panel
Dimensions: 483 x 400 x 89 mm
  Rack installation with 2 U
Weight: 8 kg